Master A3, Manual, Page: 30 / 34

30
EN
A. Put half circle connector (6) into hanger support channel (7) through the channel.
B. Thread the assembled component in step A through top support bar (1).
C. Place the assembled component in step A in place and fasten another half circle connector (6) to it using
Hex Bolt (A1), Hex Bolt (A4), M8 Nylon Washer (X2) and M8 Safety Nut (U2).
D. Connect Strengthen the Slice (A) (4), Strengthen the Slice (B) (5) and top support bar with Hex Bolt (A4),
M8 Nylon Washer (X2), M8 Safety Nut (U2) and plug gym set leg (2) into the gate of Strengthen the Slice
(A) and Strengthen the Slice (B) for both side. Connect gym set leg (2) and Strengthen the Slice (B) (5) with
Hex Bolt (A3), M8 Nylon Washer (X2), M8 Safety Nut (U2) for both side.
E. Connect side girt (3) to gym set leg (2) using M6X60 Hex Bolt (B4), M6 Nylon Washer (X1), M6 Safety Nut
(U1) for both side.
Reserve holes in order to
assemble the slide here