Master Spas legacy whirlpool, Owner'S Manual

Page: 45 / 64

43 DO NOT DIVE.
Spa Controls - 120V Models
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by “Pr ” The Priming mode
will last for less than 5 minutes (press “warm” or “cool” to skip Priming Mode) and then the spa
will begin to heat the spa and maintain the water temperature in the Standard mode.
Temp (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is constantly dis-
played on the LCD.
Note that the last measured spa temperature displayed is current only when the low speed of
pump 1 has been running for at least 2 minutes.
To display the set temperature, press the “warm” or “cool” pad.
Temperature setting is accomplished by pressing “warm” to increase the temperature or “cool” to
decrease the temperature.
After three seconds, the LCD will stop flashing and display the current spa temperature.
Jets
Touch the “Jets” button once to turn pump 1 on or off, and to shift between low and high
speeds. If left running, the pump will turn off after a time-out period.
Light (if equipped)
Press the “Light” button to turn the light on and off. If left on, the light automatically turns off
after 4 hours.
L.E.D. Light (if installed)
Press the “Light” button to turn the light on and off. If you wish to change the “function” of the
lights, turn the lights off, then on within 5 seconds.