Use only one piece, cup-type hole-cutters.
Do not use fly or multi-part hole cutters as they
can come apart or become unbalance in use.
Keep speed below 1500rpm.
•
Drum sanders must never be used on this drill press
at a speed greater than 1800rpm.
•
Do not install or use any drill bit that exceeds 7” in
length or extends 6” below the chuck jaws. They can
suddenly bend outward or break.
•
Do not use wire wheels, router bits, shaper cutters,
circle (fly) cutters or rotary planers on this drill press.
KICKBACK
To reduce the possibility of injury from kickback,
clamp the work piece firmly to the table.
ELECTRICAL REQUIREMENTS
General Electrical Connections
Use only grounded 3-prong sockets. See Fig.A
DANGER:
To reduce the risk of electrocution:
1. Use only identical replacement parts when
servicing. Servicing should be performed by a
qualified service technician.
2. Do not use the tool in rain or where floor is wet.
This tool is intended for indoor residential use
only.
WARNING:
when plugging or unplugging the power
cord, hold the plug by its body keeping the fingers
away from the terminals.
1) Head Assembly
2) Column
3) Bracket assembly
4) Base
5) Column support flange
6) Rack
7) Crank handle
8) Feed handle
9) Chuck
10) Rack ring
11) Table
12)
On / Off switch
NOT ALL THE ACCESSORIES ILLUSTRATED OR
DESCRIBED ARE INCLUDED WITH THE TOOL.
183619
Summary of Contents for 183619
Page 10: ...Exploded View...
