7
Operating Instructions and Owner’s Manual
Master Forge Wood Pellet Fire Stove
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied to heater
for shipment.
3. Check heater for any shipping damage. If any
damage is found immediately contact the
manufacturer at 800-251-0001.
CAUTION: DAMAGED PARTS MAY
COMPROMISE SAFE OPERATION.
•
DO NOT INSTALL INCOMPLETE COMPONENTS.
•
DO NOT INSTALL SUBSTITUTE COMPONENTS.
•
DO NOT INSTALL DAMAGED COMPONENTS.
4. Some components are packaged unattached from
the stove in order to ensure their safety during
shipping. Please find the protective packaging, likely
inside the stove door, to proceed with assembly.
ASSEMBLY
STEP 1 - Display Panel
Insert the display panel into the top and rear of the
stove. Be sure that the display panel screen is facing
towards the front of the stove. Secure the screen using
two of the provided screws.
STEP 2 - Display Panel Power Cord
This cord should be wrapped up near the top of the
stove. Insert free end into the back of the display
panel (see figure 15 on page 15). This wire should
already be connected to the stove’s power board. This
connection can be checked behind the access plate at
the bottom and rear of stove.
STEP 3 - Main Power Cord
The main power cord attaches to the stove at the
exposed socket in the rear of the stove. Once any
necessary assembly of the display panel screen is
complete you may briefly plug your stove in to make
sure that it functions properly before proceeding with
installation. Unplug the stove once you confirm that
the display panel works.
CAUTION: DO NOT LEAVE THE STOVE
PLUGGED INTO ANY ELECTRICAL SUPPLY
DURING ASSEMBLY OR INSTALLATION.
STEP 4 - Firepot
With the stove unplugged from any power supply, the
firepot should be inserted into the stove so that it is
securely positioned and also the hot surface igniter
should be able to make physical contact with pellets
that would be held in the firepot. See Figure 2.
Figure 2: Firepot
41
A cleaning tool is also packaged which facilitates safely
cleaning the firepot perforations of debris.
Step 5 - Air Intake Kit
Locate the air intake kit packaged with the stove. See
Figure 3. Take measurements of your space and plan
for the installation of horizontal venting to the outside
as may be required per recommendations in “FRESH
AIR AND VENTILATION REQUIREMENTS” on page
8. Follow all ventilation requirements and guidelines
specified in “INSTALLATION” on page 8.
Termination Cap
2” Flex Hose
Hose Clamp
Figure 3
Intake Kit
Step 6 - Exhaust Duct Adapter
Locate the exhaust outlet pipe for your model of stove.
During assembly of the exhaust duct adapter be sure to
sandwich the sealing gasket between the duct adapter
and the stove. Use four of the provided screws to
complete the assembly. See Figure 4.
Figure 4: Exhaust Duct Adapter & Gasket
