Page 25
WARNING:
Before performing any adjustment,
make sure the tool is unplugged from the power supply.
Failure to heed this warning could result in serious personal
injury.
• Set both the bevel angle and the miter table at 0°.
• Use the work piece clamp or a C-clamp to secure a piece
of scrap wood.
• Plug the saw into the power source and make a slight cut
to score the wood.
• Raise the cutting head and turn on the laser guide. The
laser line is near the center of the work piece.
• Unplug the saw. To adjust the laser, loosen the four
screws (B) on the right laser guide box assembly (C) with
the Phillips screwdriver on the blade wrench and remove
the left laser guide box assembly (D) and right laser guide
box assembly (C). (Fig. 16b)
• Loosen the three screws (E) on the laser guide base (F)
and slide the laser guide base to left or right until the laser
line is properly aligned. (Fig. 16c)
ADJUSTMENT
WARNING:
Use of controls or adjustments or
performance of procedures other than those specified herein
may result in hazardous radiation exposure.
WARNING:
• The use of optical instruments with this product will
increase eye hazard.
• Do not attempt to repair or disassemble the laser. If
unqualified persons attempt to repair this laser product,
serious injury may result. Any repair required on this laser
product should be performed by authorized service center
personnel.
CAUTION:
Always make practice cuts on scrap
wood before cutting through your work piece.
CAUTION:
When properly aligned, the laser should
be on the left edge of the kerf. (Fig. 16d)
• Once aligned, tighten the screws (E) on the laser guide
base (F) (Fig. 16c) and replace the left and right laser
guide box (D, C) and tighten four screws (B) (Fig. 16b).
be set up before use. Please adhere to the following
instructions.
FIG. 16d
G. Saw blade
H. Laser line
I. Work piece
FIG. 16b
FIG. 16c
B
B
B
E
E
F
E
B
D
C
G
H
I
Summary of Contents for 240-0028
Page 44: ......
