Draining the gearbox oil
– Switch off the motor.
– Disconnect the spark plug.
– Hold a collecting container below the
gearbox oil drain plug (37).
– Unscrew and remove the gearbox oil filling
plug (36) and gearbox oil drain plug (37) using a
suitable tool.
– Allow the gearbox oil to drain completely.
– Insert the gearbox oil drain plug (37) and
tighten using a suitable tool.
– Top up gearbox oil before using again.
Cleaning/replacing the air filter
CAUTION
Product damage!
The product must never be operated without the air filter, as this can cause
damage to the motor.
The air filter must be replaced if it is damaged or badly contaminated.
– Switch off the motor.
– Disconnect the spark plug.
– Remove the bolts and air filter cover. Be careful to prevent dirt and debris from falling into the
air filter base opening.
– Remove the foam element or paper element.
– Check, clean or replace the damaged air cleaner parts.
– Reinstall the air filter parts, then bolt and screw down it.
WARNING
Never clean the air filter element with gasoline or low flash-point detergents, or
explosion may happen.
CAUTION
Clean the foam filter with soapy water, blow the paper element with compressed
air or lightly tap off dust and never dry to brush.
Cleaning/replacing the spark plug
CAUTION
Product damage!
To clean the spark plug, use only wire brushes with brass bristles. Bristles of any
other material will damage the electrode!
CAUTION
Product damage!
Fit the spark plug only when motor is cold.