20
Lighting Instructions
Product no. 085-3250-4 (TF2201804-MC) |
Contact us: 1-855-803-9313
Step
Procedure
Illustration
DANGER:
Do not lean over appliance while lighting.
CAUTION:
If burner does not light OR if burner flame is accidentally extinguished, turn knob to “OFF”, wait 5
minutes, and try again. If the burner does not ignite with valve open OR if burner flame is accidentally
extinguished after lighting, gas will continue to flow out of the burner and could accidentally ignite
with risk of injury.
7
To turn burner off, turn the control knob
clockwise until it locks in the “OFF” position.
ON
OFF
8
MATCH-LIGHTING
Swing the match hole cover to expose the match
lighting hole. Place lit match into the match lighting
hole of the appliance as shown below. Make sure lit
match is placed inside the hole and near the burner.
Push in and turn the control knob slowly all the way
to “ON”. Make sure that the burner lights and stays
lit. Once lit, swing the match hole cover back to its
original position. Caution: Cover may be hot.
Holes in Burner
Good
Bad
Yellow
Blue
Blue
Yellow
BURNER FLAME CHECK
Light burner then rotate regulator knob from HIGH to LOW. You should see a
smaller flame in the LOW position than in HIGH. Always check flame prior to
each use. The air damper mounted on the back of your burner helps to control
the amount of primary air that mixes with the LP gas. A blue flame with little
or no yellow flame provides the best heat. Adjust the air damper by turning it
clockwise or counter-clockwise until the desired flame is achieved.
