•
1
rst
order LPF & 3
rd
-order HPF built-in a two-way crossover
•
Rubber feet for desktop use
•
2x M5 insert nuts for optional SP-5A bracket
2. CONTROL AND CONNECTION PANNEL (Active cabinet)
A:
SPEAKER OUTPUT connector: Output signal to feed the right
passive speaker (4 ohm)
B:
5-pin terminal block stereo INPUT connector: Connect the audio
source to this connector (balanced, sensitivity 1.5V)
C:
L&R RCA stereo INPUT connector: Connect the audio source to
this connector (unbalanced, sensitivity 1V)
D:
3.5mm stereo Mini Jack INPUT connector: Connect the audio
source to this connector (unbalanced, sensitivity 0.775V)
E:
3.5mm Mini Jack SUB OUT connector: When desired, connect an
active subwoofer to this output for increasing bass reproduction
F:
3.5mm Mini Jack LINK OUT connector: If necessary, connect to
another pair of active speakers
G:
POWER/STANDBY LED
1
: Illuminates in green when powered
(power switch set to ON or STBY). Illuminates in red when in the
standby mode (power switch is set to STBY)
H:
VOLUME: Rotate the button to adjust the audio volume
I:
TREBLE: Rotate the button to control de treble
J:
BASS: Rotate the button to control de bass
K:
POWER switch: For tuning the unit ON, OFF, STBY shutoff
2
L:
AC-Input power supply: Connect to the AC power cord. For your
safety, use always a power outlet with ground terminal
1
In the STBY mode, the LED illuminates green if an input signal is detected
and illuminates red if idle for over 2 minutes
2
When selecting the STBY shutoff mode, the speaker enters the standby
mode when idle for over 2 minutes (only 0,7W consumption)
Summary of Contents for B Series B5A
