Masport Inbuilt Gas Fires
- 8 -
19/11/04
FASCIA INSTALLATION
Piccolo Fascia
1)
The power cord should be run behind the fascia
panel and out through the slot in the bottom of the
fascia. The rubber grommet on the power cord
should be inserted into the slot to protect the
mains lead against possible damage.
Insert the fan switch (if has not already been
inserted) in the rectangular hole in the left side of
the left fascia panel.
Connect the fan wires in the following
positions.(See Piccolo wiring diagram Page 20.)
Brown wire
to
central terminal,
Red wire
to
top terminal,
Orange wire
to
bottom terminal.
2) Attach the assembled fascia to the case using six
screws.
Sofia EIS Fascia
1) There are three switches supplied with the fascia. If
they have not already been assembled, insert them
in the rectangular holes in the left side of the left
fascia panel. The FAN switch (three terminals)
goes in the bottom hole either way up. The burner
HI/LO switch (two terminals with no printing on the
rocker) goes in the centre hole with the two
terminals at the bottom. The ON/OFF switch (two
terminals) fits in the top hole with the terminals at
the top. (See drawing).
2) Connect the fan wires, red, violet and black, to the
bottom fan switch, in the following positions. (See
drawing).
- Black wire
to
centre terminal,
- Red wire
to
bottom terminal,
- Violet wire
to
top terminal.
3) Connect the burner HI/LO wires, yellow and black,
to the centre switch in the following positions. (See
drawing).
- Black wire
to
top/centre terminal,
- Yellow wire
to
bottom terminal.
4) Connect the burner ON/OFF wires, blue and black,
to the top switch in the following positions. (See
drawing).
- Blue wire
to
upper terminal,
- Black wire
to
lower terminal
5) Ensure that the wires are away from the side of the
fireplace. The power cord should be run behind the
fascia panel and out through the slot in the side of
the fascia. The rubber grommet on the power cord
should be inserted into the slot to protect the mains
lead against possible damage.
BLACK
BLUE
BLACK
BLACK
YELLOW
VIOLET
RED
FIRE:
OFF
ON
FIRE:
HIGH
LOW
FAN:
HIGH
OFF
LOW
6) Offer the fascia assembly up to the case and
connect the green earth wire to the tab on the
control valve. Then secure the fascia through the
two holes on the inner edges of each fascia side
panel and the two holes under the top rail, using
the self tapping screws provided.
Madrid ECS Fascia
1) Offer the fascia assembly up to the case and then
secure the fascia through the two holes on the
inner edges of each fascia side panel and the two
holes under the top rail, using the self tapping
screws provided
FLUSH FRONT GLASS REMOVAL
1)
Remove the top louvre by lifting it upwards and
outwards to clear the retaining pins.
2)
Remove the two trim fastening screws, one at
each end of the top trim as per the diagram below
and remove the top glass trim.
3)
Remove the two black cover trims one at each
side of the glass by lifting them upwards and then
out. Refer to the diagram. Pull the top of the trim
forward before the bottom.
4)
This will now free the glass for removal from the
fire and give access to the logs, burner etc.
SIDE GLASS
TRIM
TOP GLASS
TRIM
TRIM FASTENING
SCREW.