Masport Inbuilt Gas Fireplace
- 12 -
LOG & EMBER PLACEMENT
1) Once either the flush or bay windows are removed
as per the above instructions the embers can be
placed in the fire.
2) Inspect the logs before ember installation. If the
logs are broken, do not use the fire until they are
replaced. Broken logs can interfere with the pilot
operation, combustion, etc.
3) LOG IDENTIFICATION
790338 - Rear log, mounting centres - 340 mm
990339 - Left Centre log, mtg. centres - 115 mm
790356 - Left Front log, mtg. centres - 93 mm
790341 - Right Lower log, mtg. centres - 122 mm
790342 - Right Upper log, length - 245 mm
790343 - Centre log, length - 255 mm
Fit the first four logs on their mounting posts on
the gas burner in the following order:-
1. The Rear log
2. The Left Centre log
3. The Left Front log
4. The Right Lower log
Place the right Upper log on top of the hollow in
the right Lower log as illustrated, maintaining the
130 dimension shown to the rear of the firebox.
Place the Top log, positioned as shown with its
butt end sitting against the raised front lip of the
burner. Verify the correct distances to the right side
of the firebox.5.
4) Spread embers between and under the logs no
further than 50 mm back from front lip of burner
and also on the floor of the firebox at each side of
the burner. Do NOT block the ventilation slots
in the burner. Embers can be placed down the
sides to hide the black steelwork etc.
5) Re-install the flush or bay window. Do not operate
the appliance with the window removed.
GAS PRESSURE TEST
The unit is preset to give the correct gas input at the
specified injector pressures shown on the label. The
maximum injector pressure is:
Gas Type
Piccolo
EIS
Low
High
Low
High
Natural Gas
0.30kPa
0.75kPa
0.35kPa
0.82kPa
Propane
0.90kPa
2.10kPa
1.00kPa
2.30kPa
The injector pressure is controlled by a regulator built
into the gas valve on EIS models. The Piccolo has a
pressure regulator separate from the valve. In all
cases, when adjusting the pressure, check it at the
outlet pressure test point on the valve. The pressure
check should be carried out with the unit burning and
the correct pressures are shown above.
Piccolo
EIS Models