Masport PG33 Gas Inbuilt
34
Diagram 1
Diagram 3
STANDARD FLUSH
DOOR
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1. Be careful
that the glass gasket does not roll up; there must
be a gap between the gasket and the door lip
to ensure that the door sits securely on the unit.
Diagram 2.
Diagram 2
INSTALLATION
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd spring. See diagram 3.
To remove the flush door, reverse the above
steps.
Optional Flush Trim
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then
attach trim to the top and bottom of Flush door.
5th Grate Tab
6) Place the bottom left front edge of Log
251 against the left edge of the burner tray
and rest the log on the cutout on Log
253.
7) Position Log 252 across the cutouts in
Logs 254 and 253. The notch in the bottom
right end fitting against the 5th grate tab.
8) Pull off ember size pieces of rockwool and
gently place them on the front of the burner
tray in the places shown in the photo below.
Do not compress the rockwool, leave it
loose.
Place rockwool in these 2 locations
on the burner tray.
251
252
250
254
253
250
254
253
251
253
250
254
253
254
252
Cutout
9) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other). If there is any flame
hesitation, check that area for any block-
age of the burner ports.
10) Install flush glass and bay glass (if used) as
per instructions in this manual.
