18
CS 4030
1. Press the push-button (04/1).
The charge status displays light according to
the charge status of the rechargeable battery.
2. Read off the charge status.
Lighting LEDs Charge status of the
rechargeable battery
Green (04/2)
The rechargeable battery is
fully charged.
Green (04/3)
and (04/4)
Rechargeable battery is
charged to over 50 %.
Green (04/4)
Rechargeable battery is
charged to less than 50 %.
Red (04/5)
The rechargeable battery is
fully discharged or the
rechargeable battery has
been overheated/
undercooled.
13.2 Check the saw chain oil
Procedure see
chapter 12.8 “Filling saw chain oil
(09)”
IMPORTANT!
Danger of damaging the chain saw
The chain saw will be severely damaged
if there is too little or even no saw chain
oil in the tank or it has dried/is sticky.
Dried/sticky saw chain oil can lead to
damage to oil-channelling components
or the oil pump.
Damage also occurs if used oil is used.
The use of used oil leads to
environmental damage!
■
Each time before starting work,
check that enough saw chain oil is
present in the tank.
■
If the oil level is low, refill saw chain
oil.
■
Do not use any used oil!
13.3 Testing the chain brake
Procedure see
chapter 12.5 “Testing the function
WARNING!
Danger of fatal injury and danger of
extremely severe injury due to a
defective chain brake
Extremely serious injury and even fatal
injury of the operator can be caused if
the chain brake does not function, e.g.
due to kickback by the running saw
chain.
■
Check the chain brake each time
before starting work.
■
Do not switch the chain saw on if the
chain brake is defective. in this case,
have the chain saw checked in a
customer service workshop.
13.4 Switching the engine on and off
CAUTION!
Danger of hearing impairment!
The operation of the chain saw causes
intense noise that can cause hearing
impairment.
■
During work with the chain saw,
wear ear protection.
NOTE
Release the chain brake each time
before switching on the chain saw.
Switching on the engine:
1. Release the chain brake.
2. Press and hold locking button (01/8) with
your thumb.
3. Press and hold the throttle lever (01/7).
4. Release the locking button (01/8). It is not
necessary to keep the locking button pressed
once the chain saw has started. The locking
button is intended to prevent inadvertent
starting of the chain saw.
Switching off the engine:
1. Release the throttle lever (01/7).
14 WORKING BEHAVIOUR AND
WORKING TECHNIQUE
NOTE
Courses in the use of chain saws and
techniques for felling trees are regularly
held by various forestry organisations.
Summary of Contents for Energy Flex CS 4030
Page 1: ...491061 B 1 06 2018 OWNER S MANUAL BATTERY CHAINSAW CS 4030 ...
Page 6: ...6 CS 4030 ...
Page 7: ...7 ...
Page 8: ...8 CS 4030 ...