Masport AB107, Owner'S Manual, Page: 21 / 48

21
3
│
PREPARATION FOR PUTTING INTO OPERATION
3.1 | UNPACKING AND INSPECTING THE CONTENTS
The riding mower is supplied wooden crate cover. For transportation reasons some machine assemblies are disassembled at the
production plant and it is necessary to install them before putting the machine into operation. The unpacking and preparation for
operation is performed by the seller within the scope of the pre-sale service.
Inspect immediately after delivery that the packed machine has not been damaged. In the event of damage inform the carrier. If the
complaint is not lodged in time, no potential demands can be claimed.
Check that the machine model is the same as you ordered. In the event of an irregularity do not unpack the machine and immediately
report this discrepancy to the supplier.
In the packaging you will find:
3.1
(1) Crate cover
(2) Steering wheel
(3) Seat
(4) Documentation (packed parts list, user's manual for the riding mower, user's manual for the engine, user's manual
for the battery, service log book)
(5) Side discharge cover
► UNPACKING
1. Using a suitable tool (e.g. crowbar or hammer, etc.) remove the crating (
1
), take out all the individually packed assemblies and
remove all reinforcing elements and packaging materials.
2. Visually inspect the machine for damage that may have occurred during transport. Also unpack all individually packed
assemblies and inspect them. In the event of any type of damage, immediately contact the supplier and do not continue with
the installation of the machine.
3. Prepare suitable ramps (
6
) to drive the machine from the pallet. Ramps are not included. If you do not use ramps there is
a
danger of damaging
parts of the machine.
4. Lift the mowing deck into the transport position by pulling the lever to the highest position ( 4.2). If you do not lift the mowing
deck, there is a risk of
seriously damaging
it.
5. Carefully drive the machine off the pallet and push it to the installation location.
3.2 | DISPOSAL OF PACKAGING MATERIALS
After unpacking everything, ensure that the packaging material is properly disposed of or recycled. The disposal must
conform to relevant waste disposal laws valid in the user's country.
Disposal may be performed by a specialised company.
3.3 | ASSEMBLY OF THE SEPARATELY PACKED ASSEMBLIES
Due to the technical nature of this task, the machine is prepared for operation by the vendor of your riding mower (according to the
following instructions).
Before starting the installation, remove all covering protective materials, locate the riding mower on an even surface and align the
front wheels to face forward.
3.3.1 SEAT, STEERING WHEEL AND BATTERY
3.3.1a
a) ATTACH THE SEAT:
►
Tilt out the seat console (
1
) by approximately 90
o
upwards. Place the seat against it and secure it using four
bolts, pre-mounted in the seat. Before tightening the bolts, set the desired position of the seat to match your
body size.
3.3.1b
b) CONNECT THE CABLE OF THE SAFETY SWITCH:
►
Connect the electric cable to the switch connector on the underside of the seat.
3.3.1c
c) INSTALL THE STEERING WHEEL:
►
Seat the steering wheel on to the shaft (
1
) and turn it so that the holes in the steering wheel and the shaft align.
►
The steering wheel has two height positions, select the appropriate height for your body size. Then insert the
supplied pin (
2
) into the hole and knock it in using a hammer.