X100M1.1ENG
X
100M User manual
6/13
HV fuse is 1A-T (delayed) and mains fuse is 4A-T (delayed) for 230V wiring and 8A-T
(delayed) for 115V wiring.
IMPORTANT: always disconnect mains plug from AC line before replacing fuses;
use only fuses for type and dimensions as indicated on the panel.
Top
Aluminium grid is for final tubes cooling and must be left free.
Switch ON your X100M !
IMPORTANT: before switch the amplifier on:
1) Check the good conditions of the mains cable (with earth connector) and the
presence of a good earth connection in the line.
2) Check speaker connection adn proper imepdance.
a) Before connecting the mains cable to X100M, put MAINS switch to OFF
position and STBY/ACTIVE switch to STANDBY position.
b) If you want to enable MIDI channel selection, put channel selector to
CRUNCH position;
c) if you want to enable front/rear switches and dedicated footswitch, select
CRUCH-LEAD;
d) if you want to access the MIDI program mode, select CLEAN (see below how
to program X100M).
e) turn all front pots counter-clockwise and all rear pots at mid position;
f) connect the guitar;
g) Switch the mains ON while stby is OFF;
h) After about two minutes, move stby switch to ACTIVE position.
Now you are ready to play: turn gently the pots of the current channel to the position you
want (see further for some start-point setups) and explore all the possibilities of X100M
sound also by acting on the rear pots.
Note: if X100M wakes up in crunch mode (MIDI enable), front and rear switches are
disabled and channel will be crunch until a valid Program change will be received.
