Opal
escence
Burner Installation & Operation Manual
Find a Dealer: (800) 345-7078 | Mason-Lite.com - 09_2021
INTERMITTENT PILOT INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
p
WARNING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions. • If you can not reach your gas
supplier, call the fire department.
B. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don’t try to repair
it, call a qualified service technician. Force
or attempted repair may result in a fire or
explosion.
C. Do not use this appliance if any part has been
under water. Immediately call a qualified ser-
vice technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above
on this label.
2. Read the Care and Operation manual
including the section on “Remote Control
System.”
3. Press ON/OFF button on remote control
transmitter to “OFF.”
4. Turn “OFF” all electric power to the
appliance.
5. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the
safety information above on this label.
If you don’t smell gas, go to the next step.
7. Turn on all electric power to the appliance.
8. Slide the switch on the receiver to REMOTE.
9. Press ON/OFF button on remote control
transmitter to “ON.”
10. Appliance will begin to light.
11. If the appliance will not operate, follow
the instructions “To Turn Off Gas To
Appliance” and call your service technician
or gas supplier.
TO TURN OFF GAS TO FIREPLACE
1. Slide the switch on the receiver to “OFF.”
2. Press ON/OFF button on remote control
transmitter to “OFF.”
3. Turn off all electric power to the appliance if
service is to be performed.
4. Close the main line gas shut-off valve.
16
