Doc.Ref.No.:m97/om/302
Issue No.:05
Page | 5
HT7S Series
S
AFETY AND WARNING
To avoid Electrostatic Discharge (ESD) to the
transmitter, that may cause permanent damage,
Operator must operate device using ESD safe tools
and clothing.
Before installation or beginning of any troubleshooting
Procedures, the power to all equipment must be turned
off and isolated. Units suspected of being faulty must
be Disconnected and removed first and brought to a
properly equipped workshop for testing and repair.
Component replacement and internal adjustments
must be done either by Masibus or done under the
guidance of Masibus.
Wiring must be carried out by skilled personnel and
correct tools.
All wiring must confirm with standards of good practice
and local codes and regulations. Wiring must be
suitable for voltage, current, and temperature rating of
the system. Beware not to over-tighten the terminal
screws.
C
ONFIGURATION AND CONNECTION
HT7S series transmitters contain four variants,
configurable as shown in below wiring diagrams.
1. Connection for HT7S00
2. Connection for HT7S10
3. Connection for HT7S11
4. Connection for HT7S11-Y
I
NSTALLATION
HT7S Series transmitter is available in wall
mounting, duct mounting and flame proof duct
mounting. Light weight wall anchors and mounting
screws are included for wall mounting and a duct
mounting kit is also available for duct mount
models.
1. Wall Mount
With mounting Plates (Provided) attach the wall
assembly plate to the wall with two screws.
2. Duct Mount and Flame Proof Duct Mounting
To install these device, loosen up the LNKey screw
available on Flange so that Flange moves easily on
Duct Pipe. Insert the Duct probe in Duct hole at
desired depth and then tighten up the LNKey screw
on Flange. After this step fix the Flange on Ducting.
Mechanical Installation
Relative humidity is extremely dependent on
temperature. Proper measurement of relative
humidity requires that the probe and its sensors be
at exactly the temperature of the environment to be
measured.
Because of this, the location where you choose to
install the probe can have a significant effect on the
performance of the instrument.