60
Steps during storage
For conventional battery, check electrolyte level every month. If the fluid level is
low, timely replenish it with distilled water or pure water to the highest level
mark. (Never use electrolyte or tap water)
Battery shall be kept clean. Corrosion may happen if electrolyte is splashed to
the vehicle body, terminal or wires. In case of corrosion, wash immediately with
clear water and apply a coat of grease after drying off.
Insufficient power may cause difficulty in engine starting, weak horn sounding
and no flashing turning signal light. Then, immediately recharge the battery for
15-20 hours. Note that, storing a low battery for a long time may cause battery
damage.
When a battery has whitened plate electrodes, low power or low fluid level
below the lower limit, and cannot restore the performance after a long time
storage even after recharging, it means the service life has been terminated.
Steps of returning service
1.
Clean the entire motorcycle.
2.
Remove spark plug; kick the kickback start lever to allow the engine
rotating for several turns, before reinstalling spark plug.
3.
Reinstall battery.
Note
：
Make sure to connect the positive connector before the negative one.
4.
Adjust tire pressure according to the tire part of the manual.
5.
Lubricate all parts that require lubrication according to the manual.
6.
"Check before riding" as instructed in the manual.
7.
Riding "before taking the road.
Summary of Contents for Two Fifty 250 cc
Page 1: ...User Manuel ...
Page 4: ......
Page 5: ......
Page 62: ...www mashmotors com Votre revendeur mash motors fr ...
