Maserati Quattroporte Automatic, Owner'S Manual

Page: 243 / 272

8
Level checks
243
Engine oil
The level must be checked with the
vehicle on a flat surface, following the
procedure below:
– Warm-up the vehicle until reaching
the standard operating temperature
– Stop the engine, remove the filler
cap A and wait 5 minutes to allow
the oil to flow into the sump
– Measure the level and top up if
necessary.
The oil level must be between the MIN
and MAX reference on the dipstick.
The gap between MIN and MAX
corresponds to about 1.5 litres
(0.33 UK gal) of oil.
WARNING: Do not exceed the MAX
level!
If the oil level is close to or below the
MIN level notch, top up to the MAX
notch through the filler neck
positioned next to the dipstick and
closed with the cap A. The oil level
should never exceed the MAX
reference mark.
WARNING: Do not top up with oil
having characteristics other than those
of the oil already used in the engine.
After topping up, the engine oil level
warning light may not go off for some
time while the system is performing
the necessary tests. This is to be
considered normal.
After having topped up or replaced
the oil, check its level once again.
WARNING: The engine oil used and the
oil filter replaced contain substances
that are dangerous for the
environment. For replacing the oil and
the filters you are advised to contact
the Maserati Service Network, where
all the necessary equipment is
available to dispose of the used oil and
filters in compliance with the
regulations in force and in an
environment-friendly manner.
MAX
MIN
A
M139_UM_ing.book Page 243 Friday, September 5, 2008 8:19 AM