MASCAR Diavel 630, Use And Maintenance Manual

Page: 18 / 72

Roundbaler DIAVEL 630
– DIAVEL 630 CUT
USE AND MAINTENANCE MANUAL - 18 -
2.4 SAFETY DEVICES
The installed devices must be always efficient and
properly positioned. In case of breakage or
damage of the safety devices, it is compulsory to
replace them before resuming work.

The limiter of the PTO couple, in case of
overload, it starts interrupting the
transmission.

PTO protection: PTO is protected in all its
mobile parts for its whole length. The
protection results to be openable to easily
remove the PTO.

Protection of the transmission shafts: the
transmission shafts which bring the motion
from the gearbox to the chains are equipped
with protections avoiding contact with the
operator.

The limiter of the collector, in case of
overload, it starts interrupting the collector
movement.

The safety valve and overcenter valves set on
the cylinders, prevent voluntary and
involuntary movements of the door. In case of
interventions with the door open, close the
relative sphere valve.

Wheels chock or parking brake, must be used
to avoid hazardous movements of the
machine once disconnected from the tractor.

Safety protections: side protections of the
machine, as per European regulations, are
equipped
with safety locks which
automatically start when the protection is
closed. In order to open such protections, the
operator will have to intervene with a suitable
tool. Once this operation is ended, the
operator will have to close protections.
WARINING
Always make sure all the protections are
activated
before leaving the machine
unattended or before its transport

PTO shaft support: the function of the
support is to hold the PTO shaft when the
machine is parked. The machine
doesn’t
have to work or be transported when the
PTO shaft is set on this support.
2.5 CLOTHING AND PERSONAL
PROTECTION
WARNING
1) Use suitable clothing. Avoid wearing ties,
necklaces, baggy or fluttery clothing as they might
get caught up in the rotating parts. Long hair
should be tied back.
2)
During the maintenance and repair work, the
use of personal safety gear is compulsory: cut-
proof gloves, non-slip safety boots.
.
2.6 ECOLOGY AND POLLUTION
The paragraph
“1.6 Noise level” contains the
values of the airborne noise measured on the
round baler. The user is responsible to inform
authorized personnel about hazards deriving from
noise and it is obliged to comply with the relevant
national standards in force.
WARNING
Since with the machine working the noise
level is in any case higher than what permitted
by the relevant standards, appropriate ear
protection must be worn.
Observe the laws in force in the country where the
machine is used related to the use and disposal of
products used for cleaning and servicing the
machine, and comply with the procedures
recommended by the manufacturers of said
products.
Verify before each use of the machine eventual
loss of lubricant or hydraulic oil. In case of
leakage restore the seals of the system before
use.
In case of dismantling the machine, comply with
the anti-pollution regulations provided in the
country of use of the machine, paying attention in
particular to:

Lubricants (oil and grease)

Oil of the hydraulic system

Electric and electronic components (batteries
and capacitors)

Braking gaskets

Tires and plastic materials