MXR
Coil
ext.
Preload
FIG. 24 (only right leg)
Fit the RH pumping element
(12)
from
stanchion top with only
one
rebound spring
(15)
on forks with a
travel of 100
, and
two
rebound springs
(15)
for a
travel of
80
.
(80)
(100)
12
15
12
15
CROWN AND STANCHIONS AS-
SEMBLY
FIG. 25
Fit the crown and stanchions assembly
(1)
- with the dust seals in place - gently into the
sliders seals.
IMPORTANT:
to avoid any damages to
sealing surfaces, keep the stanchions duly
lubricated and squared into the sliders.
Press the crown and stanchions assembly
fully down and check that threaded ends of
pumping elements
(14)
and
(12)
are com-
ing out through the bottom of the sliders.
Check to see that the stanchions slide unre-
stricted by cycling the fork up and down
several times.
The tube should slide freely inside the seal
assembly without any side play. In the event
it is too hard or too soft, repeat the previous
steps described above and check compo-
nents to ensure they are not damaged.
Seat the dust seals
(19)
on top of the
sliders.
1
19
19
FIG. 26
Screw the foot nuts
(26)
and
(29)
on the
threaded elements of pumping elements
(14)
and
(12)
.
Tighten to 11 Nm.
Check to verify that the stanchions slide
properly through the stroke by pumping
them up and down several times.
26
29
Sx.
Dx.
Nm
11
