Using a hammer, knock in introducer (
A
) and drive the sealing ring home into the arch-slider assembly.
Using a small flat-tip screwdriver, fit the stop ring (
2
) and check that it fits perfectly into its groove.
Take great care not to damage the internal surfaces of the one-piece assembly when fitting
the stop ring.
The dust seals shall be refitted when reassembling the crown-stanchion unit / arch-slider assembly.
Assembling:
During the assembly of the pumping unit, strictly obey the instructions below.
Do not, at any times, reverse the position of the pumping elements in the fork legs (if you are unsure about anything, please refer
to the relevant exploded view).
Assembling: Assembling the right pumping element and valve
Replace the segment (
8
) of the pumping element, if necessary.
Insert the preload tube (
9
) (
only for models with 105mm travel
)
and the rebound spring (
7
) in the piston
rod.
Assemble the valve unit in this order: bushing (
4
),valve (
5
), three-point ring (
6
), and check that the parts
are oriented as shown.
© Marzocchi Suspension
2005
-
MX Comp ETA