Screw the lock cap (
2
) down on the rod of the ETA cartridge without tightening being very careful not to
damage the O-ring.
Check that O-ring is not damaged.
Using the 21mm socket spanner, tighten cap (
2
) to the recommended tightening torque (
10 Nm ± 1
).
Restore the correct air pressure (see settings).
Fit the protection cap (
1
).
Screw the lock cap (
2
) down on the rod of the ETA cartridge without tightening being very careful not to
damage the O-ring.
Push washer (
7
) and the preload tube (
8
) downwards so you can reach locknut (
6
) with a 10mm spanner.
Using the 10mm and 21mm spanners, tighten locknut (
6
) on cap (
2
) to the recommended tightening
torque (
6 Nm ± 1
).
Fit the control knob (
5
), washer (
3
) and screw (
4
).
Using a 2mm Allen key, tighten the knob fixing screw (
4
) to the recommended tightening torque (
2 Nm
± 0.5
).
© Marzocchi Suspension
2005
-
Marathon XC
