18
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate corre-
spond to your domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted in the two top cor-
ners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
D594
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow accu-
rate levelling of the appliance.
NP008
100 mm
15 mm
15 mm
A
B
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC
of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent modifi-
cations.
CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, check
that:
•
the plug is firmly in the wall socket and the
mains power switch is on;
•
there is an electricity supply (find out by plugging
in another appliance);
•
the thermostat knob is in the correct position.
•
If there are water drops on the bottom of the
cabinet, check that the defrost water drain open-
ing is not obstructed (see “Defrosting” section).
•
If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the guar-
antee certificate or on the rating plate located inside
the appliance, on the bottom left-hand side.