(
Increase the
Depth of Cut
Knob
Wheel
7 Make sure the blade is rotating ( at least falf throt
tle) before inserting the blade into the cut Ihe
Edger performs best at full throttle
8 Always release the throttle trigger and allow the
engine to return to idle speed when not cutting
9.
Stop the Edger engine when moving between
work sites.
A
CAUTION
• Always wear gloves and protective cloth
ing when operating the Edger.
• If the Edger blade becomes jammed, stop the
engine immediately
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage
• Never use a Edger that has chipped, cracked or
broken Edger blade or blade shield
Setting Depth of Cut
IMPORTANT: Set the depth of cut before you
start the engine.
Loosen the knob holding the shield to the plate
2 Rotate the shield as necessary to set the depth of
cut Note that:
• Rotating the shield to raise the wheel increases
the depth of cut
• Rotating the shield to lower the wheel
decreases the depth of cut
3
Make sure the shield is positioned to protect the
operator from thrown debris, then tighten the
knob
Maintenance
Maintenance, replacement or repair of emission
control devices and systems may be performed by
any repair establishment or individual; however;
warranty repairs must be per
f
ormed by a dealer or·
service center authorized by Maruyama
Manufacturing Company, Inc. The use of parts that
are not equivalent in per
f
ormance and durability to
authorized parts may impair the effectiveness of the
emission control system and may have a bearing on
the outcome of a warranty claim.
Idle Speed Adjustment
fhis Edger is equipped with non-adjustable fuel mix
ture carburetor. Ihe engine idle speed is the only
adjustment for the operator.
A
WARNING
• Idle speed adjustment should be
checked each time the unit is operated.
-20-
