MARUTI SUZUKI Wagon R, Manual

Page: 12 / 240

00-9 Precautions:
Air Bag Warning
AENAR90A0000010
WARNING
!
For vehicles equipped with Supplemental
Restraint (Air Bag) System:
• Service on and around the air bag system
components or wiring must be performed
only by a MARUTI SUZUKI authorized
dealer. Refer to “Air Bag System
Component, Wiring and Connector
Location”: in Section 8B in order to
confirm whether you are performing
service on or near the air bag system
components or wiring. Please observe all
WARNINGS in Air Bag System section and
“Precautions on Air Bag System Service”:
in Section 8B before performing service on
or around the air bag system components
or wiring. Failure to follow WARNINGS
could result in unintentional activation of
the system or could render the system
inoperative. Either of these two conditions
may result in severe injury.
• Technical service work must be started at
least 90 seconds after the ignition switch is
turned to the LOCK position and the
negative cable is disconnected from the
battery. Otherwise, the system may be
activated by reserve energy in the SDM.
LPG Warning
AENAR90A0000011
WARNING
!
• Make sure to relieve LPG pressure
referring to “Fuel Pressure Relief
Procedure”: LPG in Section 1G, before
removing line parts. Otherwise, the part
can pop out suddenly from LPG line and
personal injury can result.
• LPG is combustible and can cause fire.
Take special precaution when handling
LPG referring to “Precautions for LPG
Vehicles”: .
Fastener Caution
AENAR90A0000012
CAUTION
!
When fasteners are removed, always reinstall
them at the same location from which they
were removed. If a fastener needs to be
replaced, use the correct part number
fastener for that application. If the correct
part number fastener is not available, a
fastener of equal size and strength (or
stronger) may be used. Fasteners that are not
reused, and those requiring thread-locking
compound, will be called out. The correct
torque value must be used when installing
fasteners that require it. If the conditions are
not followed, parts or system damage could
result.
Suspension Caution
AENAR90A0000013
CAUTION
!
• All suspension fasteners are an important
attaching part in that it could affect the
performance of vital parts and systems,
and/or could result in major repair
expense. They must be replaced with one
of the same part number or with an
equivalent part if replacement becomes
necessary. Do not use a replacement part
of lesser quality or substitute design.
Torque values must be used as specified
during reassembly to assure proper
retention of this part.
• Never attempt to heat, quench or
straighten any suspension part. Replace it
with a new part or damage to the part may
result.
Wheels and Tires Caution
AENAR90A0000014
CAUTION
!
All wheel fasteners are important attaching
parts in that they could affect the
performance of vital parts and systems, and/
or could result in major repair expense. They
must be replaced with one of the same part
number or with an equivalent part if
replacement becomes necessary. Do not use
a replacement part of lesser quality or
substitute design. Torque values must be
used as specified during reassembly to
assure proper retention of all parts.
There is to be no welding as it may result in
extensive damage and weakening of the
metal.