70
797-74E-I
Omni MPI
INSPECTION AND MAINTENANCE
9-11
CAUTION
It is dangerous to remove the
radiator cap when the water
temperature is high, because
scalding fluid and steam may be
blown out under pressure. Wait until
the coolant temperature has lowered
before removing the cap.
Coolant Replacement
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized MARUTI
SUZUKI dealer.
•
When adding or replacing coolant,
use a high quality ethylene glycol
antifreeze and anticorrosion (Non-
Amine type) diluted with distilled
water. If the lowest ambient
temperature in your area is
expected to be -15
0
C (5
0
F) or
above, make the antifreeze
concentration of the mixture you
use at least 30% but no more than
50%. If -16
0
C (3
0
F) or below, make
the concentration at least 50%. If
the 50% concentration does not
provide adequate protection
against freezing, follow the
instructions on the antifreeze
container to obtain the desired
freezing point.
70F-07-018F
w
WARNING
WINDSCREEN WASHER FLUID
Do not use “anti-freeze” solution in
the windscreen washer reservoir. This
can severely impair visibility when
sprayed on the windscreen, and can
also damage your vehicle’s paint.
w
WARNING
797-09-007
Check that there is washer fluid in the tank.
Refill it if necessary. Use a good quality
windscreen washer fluid, diluted with water
as necessary.
CAUTION
Damage may result if the washer
motor is operated whilst the fluid or
fluid nozzles are frozen or with no
fluid in the washer tank.