MODEL: V242L V262L
- 11 -
STARTING THE ENGINE
&
ENGINE MODEL: GX Series , TLE Series
Press lever (J) and hold lever (I). Release levers (J) and (I)
while keeping knob (L) pressed. The throttle lever (I) is
now in its partial acceleration position, in order to let the
engine start more quickly and easily. Push knob (H) in the
“
'
START” direction (Fig. 9-9).
Start the engine according to its operation and
maintenance manual.
After starting the engine, pull throttle lever (I) once again
and release it right away in order to unlock it from the
partial acceleration position and to let the engine idle
when lever (I) is released.
&
ENGINE MODEL: TJ Series
Push knob (H) in the “
'
START” direction (Fig. 9-9).
Push the priming pump (D:Fig. 9-5) several times.
Move the choke lever (E:Fig. 9-5) to the “START”
position.
Pull the recoil starter grip (F:Fig. 9-5) firmly and rapidly
until the engine fires (Fig. 9-6).
NOTE:
If you pull lever (I), the choke lever (E:Fig. 9-5)
will return by itself.
J
H
L
NOTE:
Please refer to the Engine Operation Manual.
STOPPING THE ENGINE
In order to stop the engine, press button (H) into its“ STOP”
position (Fig. 9-10).
K
I
Fig.9-8
WARNING:
When the engine is switched off, the rotating
part, blade or nylon string head, will keep on rotating for a
few seconds. Hold the machine until all parts come to a
standstill.
NOTE:
In the event of an emergency, the time required for
the disc or the string cutter head to stop can be reduced by
resting the cutting tool level onto the ground. The ring nut
(K) located on the control handle is for adjusting the engine.
By turning ring nut (K) clockwise, the engine rpm is reduced
during the subsequent use of throttle lever (I).
Conversely, turning ring nut (K) counterclockwise raises the
engine rpm.
Therefore, adjust ring nut (K) according to the operating
conditions.
Fig.9-9
Fig.9-10
