Page 4
Getting Started
General warnings
1. The TrackPod is not for domestic use.
2. Use the device only as described in this manual.
3. Do not expose it to rain or moisture.
4. The TrackPod controller does not have an ON/OFF switch. It turns
ON automatically when it is connected to the mains. Therefore, before
connecting, please make sure to switch the TrackPod controller’s
power to 115 or 230V according to your needs.
5. Make sure the device is properly grounded.
6. Immediately repair or replace damaged power cords.
7. There are no user-serviceable parts inside; refer all service to a
qualified technician.
Laser information
The TrackPod contains a class 3A laser calibrator with a 5mW maxi-
mum power output. It is located below and protruding from the Track-
Pod’s general-purpose attachment plate, between the two counter-
weights and within a grounded enclosure (see Figure 1 in the next page).
The only aperture through which laser light is emitted is directly in the
centre of the grounded enclosure, with the beam being colinear with the
attachment plate.
The laser produces an intense, highly directional beam of light. It is
needed only briefly during the TrackPod calibration procedures and
cannot be turned on during normal operation. The TrackPod’s laser will
only turn ON when all the following conditions are met:
1. The TrackPod is powered on.
2. The laser is connected to the TrackPod controller.
3. The TrackPod is connected to the control PC.
4. The TrackPod software is running in the control PC.
5. The TrackPod is in the automatic calibration mode. Tip: you may
block access to this mode to prevent unauthorized operators from
calibrating the instrument. Set the appropriate access priviledges in
the preferences screen of the TrackPod software.
6. The laser aperture is not blocked by a lid or cap.
7. The F3 button in the TrackPod controller is pressed. Releasing the F3
button stops laser emission.
www.audiovias.com
