© Martin Engineering GmbH
6
M3625UK-10/15
Introduction
2.2
Appropriate Use
The MARTIN
®
Tracker conveyor belt centring system is only meant
to be installed in the carrying run and return run of conveyor belts in
order to correct skewed running of the conveyor belt. In the process,
it is differentiated between the upper and lower unit. The upper unit
is placed on the support side of the conveyor belt and the lower unit
on the return side.
The Martin
®
Tracker conveyor belt centring system can be used un-
der the most diverse conditions of use. There are different models
available for this purpose, which should be used only in the ranges
specified for them. The different models and their applications are
specified in detail in the Chapter 3.2 "Models".
Any other use of this product is deemed to be inappropriate. If you
wish to use the product for any other purpose, please contact Martin
Engineering Customer Service. We will be happy to assist you with
product configuration.
2.2.1
Use in EX-protection areas
Under certain circumstances, this product can also be used in po-
tentially explosive areas. Contact Martin Engineering for more infor-
mation on use in potentially explosive areas.
The use of the product in a device protection category that is higher
than that specified or under operating conditions other than those
specified by Martin Engineering is not permissible or may be done
only if Martin Engineering has granted its approval.
