20
Control panel
R E A D O U T S
The MiniMAC Maestro provides readouts to track usage, maintenance intervals,
lamp life, and software version. Values from 1000 to 9999 are automatically
scrolled and counters roll over to 0 when they reach 10,000.
T o d i s p l a y o r r e s e t a r e a d o u t
1 Scroll to
I n f
in the main menu, press [enter] and scroll to the desired readout.
Press [enter] and scroll to the desired option. Press [enter] to display the information.
2 (Optional) To reset a counter, press [up] until the readout displays
0
.
T E S T P R O G R A M S
Test sequence: The test sequence allows you to check all effects quickly. At the end
of the test cycle, effects return to their home position briefly before the test repeats.
To run the test, navigate to
t S t
/
t S E
/
r u n
and press [enter]. To stop the test,
press [menu].
PCb: For service use only. Executing this test with motors connected may cause
damage to the circuit board.
T o t e s t D M X c o n t r o l v a l u e s
1 On the controller, program a set of commands for the fixture.
2 Scroll to
t S t
in the main menu, press [enter] and scroll to
L O g
. Press [enter].
3 Press [enter] to display the start code. The start code must be 0. Press [menu].
4 Scroll through the effects and press [enter] to display the DMX values received.
Compare the values with the DMX protocol.
U P L O A D M O D E
Software upload mode is normally engaged automatically. Use this option only if
automatic upload fails. See “Installing software” on page 43.
M A N U A L C O N T R O L
The manual control menu (
C t r
) provides limited manual operation and is used to
program and execute scenes as in Stand-alone mode.