18
MAC 600 (E) NT
O
PTICAL
CONFIGURATIONS
8
Field angles
Narrow and wide angle options are available for the MAC 600 (E) NT. The optional lenses are mounted in snap-lock
hoods for easy changing. See “Accessories” on page 31.
Note: The narrow angle hood is longer than the standard hood. Because of this, MAC 600s and MAC 600 (E) NTs
fitted with the narrow angle hood fit only in flight cases produced after September, 1997. These measure 894 mm
(35.2") from bottom to top, including wheels. Earlier flight cases measure 860 mm (34") from bottom to top, including
wheels.
To c ha nge f i el d a ngl e
1
Release the snap locks and remove the hood and lens assembly.
2
Unhook the head safety wire from the hood being removed and place it on the one being installed.
3
Place the hood over the head. Align and close the snap locks.
Color filters
The color wheel provides 4 dichroic glass filters: red 308, green 203, blue 108 and UV. The filters are held by a spring
clip and may be removed. To avoid damaging the coating, wear clean lint-free gloves when handling the filters.
T o r e mov e a n d i n st al l a c ol or fi l te r
1
Disconnect the fixture from AC power and allow it to cool. Unlatch and remove the front head section.
2
Turn the desired filter position to the access cut-out.
3
To remove a filter, tilt the outside corner forwards past the retention tabs and slide it out of the clip.
4
To install a filter, carefully align the inside corner with the corner of the hub. Slide each side of the filter under
the spring clip, starting at the leading edge as shown. If necessary, bend the wheel back gently to start the
filter under the spring. Slide the filter in until it snaps into place.
red
green
blue
UV
Summary of Contents for MAC 600 NT
Page 1: ...MAC 600 E NT user manual...
