24
MAC 550 Profile
Software installation
Software updates are available from the Martin web site and can be installed via the data link with a Martin upload
device.
The following are required in order to install software.
• The MAC 550 Profile update file, available for download from the User Support Area of the Martin web site
(http://www.martin.com).
• The Martin Software Uploader program, version 5.0 or later, available for download from the User Support Area of the
Martin web site.
• A Martin MP-2 Uploader connected to a Windows 95/98/ME/2000/XP PC, or one of the PC controller DMX
interfaces supported by the Martin Software Uploader software.
T o i n s ta l l s of t war e , n o r mal me th o d
Please refer to the MP-2 user manual and the Martin Software Uploader online help file.
T o i n s ta l l s of t war e i f al l el s e f ai l s ( b o ot s ect o r u p da te )
Note: Use this procedure only if the firmware is totally corrupted, which is evident if the control panel does not
respond when power is applied, or if the software update notes call for a boot sector update. In the event of a check
sum error, repeat the normal upload procedure.
1
Disconnect the fixture from power.
2
Remove the side cover from the side of the base that has the control panel to expose the main PCB.
3
Locate the “BOOT” jumper on the main PCB (see page 36) and move the jumper cap to the “INIT” position.
4
Perform a boot mode upload as described in the uploader documentation.
5
When the upload is complete, disconnect the fixture from power and move the jumper back to the
“DISABLE” position.
6
Reassemble the base.
Figure 16: Air filter replacement
Downloaded from
www.Manualslib.com
manuals search engine