Martin Engineering M3910-04/19
12
Martin
®
Electric Vibrators
Figure 8. Installing Wire Connector
4. Install wire connector between the two flat washers. See Figure 8.
WARNING
!
Vibrator must be grounded using the power supply ground
wire (or other if specified in the NEC). Failure to properly
ground vibrator can cause severe injury or death.
5. Connect power supply ground wire (or other if specified in the NEC) to
ground vibrator terminal. Use closed loop wire connector only.
6. Reassemble wiring cover, o-ring, and rubber compression block(s),
taking care not to pinch the o-ring. Tighten cord grip around supply
line(s).
Wire
connector
Flat
washers
Installation