Martin Engineering M4101-01/19
4
Martin
®
HD QB1™ Cleaner
Before Installing Belt Cleaner
IMPORTANT
The delivery service is responsible for damage occurring in
transit. Martin Engineering CANNOT enter claims for
damages. Contact your transportation agent for more
information.
1. Inspect shipping container for damage. Report damage to delivery service
immediately and fill out delivery service’s claim form. Keep any damaged
goods subject to examination.
2. Remove belt cleaner assembly from shipping container.
3. If anything is missing contact Martin Engineering or a representative.
DANGER
!
Before installing, servicing, or adjusting the belt cleaner, turn
off and lockout / tagout / blockout / testout all energy sources
to the conveyor and conveyor accessories according to ANSI
standards. Failure to do so could result in serious injury or
death.
4. Turn off and lockout / tagout / blockout / testout energy source according
to ANSI standards (see “References”).
DANGER
!
If this equipment will be installed in an enclosed area, test the
gas level or dust content before using a cutting torch or
welding. Using a torch or welding in an area with gas or dust
may cause an explosion resulting in serious injury or death.
Follow local confined space procedures.
5. If using a cutting torch or welding, test atmosphere for gas level or dust
content. Cover conveyor belt with fire retardant cover.
IMPORTANT
Center the belt cleaner blades to clean an area narrower than
the conveyor belt width. This allows for side-to-side movement
of the belt and prevents damage to the belt edge.
NOTE
The chute wall that the tensioner will be located on is referred
to as the “operator side.” The other side of the chute is
referred to as the “far side.” (If installing dual tensioners, side
that is most accessible is “operator side.”)
Before Installation
