Martin EvenLED RGB LED Panel, User Manual

Page: 24 / 32

24 EvenLED user manual
Service and maintenance
DANGER! Read “Safety Information” on page 3 before carrying out service or maintenance work on
the EvenLED. Disconnect the panel from power before cleaning.
Important! The EvenLED requires periodic cleaning to maintain reliable operation and protect the
investment it represents. Excessive dirt and particle buildup degrades performance, causes
overheating and may cause damage that is not covered by the product warranty.
The user will need to carry out periodic cleaning, and it is also possible for the user to update the EvenLED
software using the Martin EvenLED Software Uploader device. All other service operations must be carried
out by Martin Professional or its approved service agents.
Installation, on-site service and maintenance can be provided worldwide by the Martin Professional Global
Service organization and its approved agents, giving owners access to Martin’s expertise and product
knowledge in a partnership that will ensure the highest level of performance throughout the product’s
lifetime. Please contact your Martin supplier for details.
It is Martin policy to apply the strictest possible calibration procedures and use the best quality materials
available to ensure optimum performance and the longest possible component lifetimes. However, LEDs are
subject to wear and tear over the life of the product, resulting in gradual changes in color and overall
brightness over many thousands of hours of use. The extent of wear and tear depends heavily on operating
conditions and environment, so it is impossible to specify precisely whether and to what extent LED
performance will be affected. However, you may eventually need to ask Martin Professional to replace LEDs
if their characteristics are affected by wear and tear after an extended period of use and if you require
panels to perform within very precise optical and color parameters.
Cleaning
Regular cleaning is essential for product life and performance. Buildup of dust and dirt degrades the panel’s
light output and cooling ability.
Cleaning schedules will vary greatly depending on the operating environment. It is therefore impossible to
specify precise cleaning intervals for the EvenLED. Inspect panels within their first few weeks of operation to
see whether cleaning is necessary. Check again at frequent intervals. This procedure will allow you to
assess cleaning requirements in your particular situation. If in doubt, consult your Martin dealer about a
suitable maintenance schedule.
Warning! Disconnect from power before cleaning. Do not allow the product to become wet. Take
care not to damage wiring.
Important! Do not use abrasives, solvents or caustic cleaning products for cleaning.
The EvenLED’s aluminum housing can be cleaned with a cloth that is slightly dampened – but not wet – with
a solution of water and a mild detergent such as car shampoo. To clean the housing:
1. Isolate the panel from AC power and allow it to cool for 20 minutes.
2. Gently wipe away dirt and dust with the damp cloth.
3. Allow any moisture to dry before reconnecting to power.
Software installation
It may be necessary to upload new software (firmware) to the EvenLED if you believe that the product has a
software-related fault or if you want to update to a newer version. Software updates are available from the
Martin website (http://www.martin.com) and can be installed via the DMX data link with the EvenLED
Software Uploader, available from Martin (P/N 90758097). See the separate EvenLED Software Uploader
user manual for details.