Operation
15
>M? mode:
In DMN mode, fixtures receive control instructions via the
serial data link. They will respond to control signals from a DMN controller
Ror from another fixture set as masterS.
Selecting DMX, music trig or auto trig op erat ing
modes
The Mania EFN is supplied set to DMN mode with DMN address set to H.
If you intend to operate the fixture without a DMN controller, you need to
set the fixture to music trig or auto trig mode.
To switch between DMN, auto trig and music trig modes:
H. Apply power to the fixture and wait
while it resets. If the fixture is in DMN
mode, the display will show the
fixture[s DMN address.
2. Press the mModen button once. The
fixture enters auto trig
mode and
#""
appears in the display.
3. Press the mModen button again once.
The fixture enters music trig
mode,
and
#"!
appears in the display.
4. Press the mModen button again once to
return to DMN mode. The fixture[s
DMN address appears in the display.
The fixture will return to the mode you have set when it is powered off and
on.
If you set the fixture to music trig mode but it does not respond
satisfactorily to the music beat, adWust the music trig sensitivity level Rsee
d
<;=8#$'"()18#'4)$9'()#+"#'$'>'$?
e on page 20S.
S y n c h r o n i z e d m u s i c t r i g a n d a u t o
t r i g o p e r a t i o n
You can set multiple fixtures on a serial data link to respond together to a
music trig or auto trig signal from one fixture. This feature allows
synchroniQed operation without a DMN controller. The fixture sending the
signal is the omaster[ fixture and the fixtures that receive the signal are the
oslave[ fixtures.
Important! Set only one fixture as master: damage can occur if two
masters, or a master and a DMX controller, are linked.
X100
X10
X1
Mode
DMX Address
[Mode] button