4. See Figure 2. Install the thumbwheels
A
supplied in the kit on the top and bottom
profiles of each panel, using the
supplied locknuts to secure them in
place so that they will not drop out of
the panel if loosened too much.
5. Insert two curved plates (or ‘bananas’)
B
supplied in the kit in their slots on the
top and bottom profiles. Once the
correct angle is obtained, lock the
columns by tightening thumbwheels
A
.
6. Install curving plates using the same
method in the slots in the bottom profile
of the Headers.
7. When the installation is disassembled,
the thumbwheels
A
can be tightened
and left in position but remove the ‘bananas’
B
and store them safely in the flightcase for possible
re-use.
8. Reinstall the alignment cones (see Figure 1) on the sides of panels and Headers before installing panels
in a flat wall.
All EC Series and P3 system controller user documentation is available for download free of charge from
the Product Support area at www.martin.com.
Figure 2: Locking panel angles in a curved array
www.martin.com
•
Olof Palmes Allé 18
•
8200 Aarhus N
•
Denmark
Tel: +45 8740 0000
•
Fax +45 8740 0010
