VII
Setting the label location in regard to the top edge of the document.
Labeler
1.
With the labeler and media both in the on position, hold down the label
key.
2.
Unit will go into the label adjustment screen.
3.
Screen will start flashing between the adjustment, and “Keys to change”
one key will increase the setting, one will decrease. Use both keys at the
same time to install.
Some experimentation may be necessary to find best location.
The approximate setting for positioning the label directly underneath the leading
edge of a document is 38. The approximate setting for the center of a NO. 10
envelope is 75. The higher the number setting the lower the label will be applied.
When you start your job the first label should be 1/8 peeled on the peel bar.
NOTE: There is no tab adjustment setting. This is only used in labeling
mode.
This should provide you with all of the information you will need. Please call
technical support at Martin Yale Industries, Inc. if you have any other questions
at 219-563-0641.
Make sure you leave
some slack to start
your backing onto the
take up spool.
Outer tab reel
and o -ring
Removable foam
drive roller.
(Remove for
easier threading.)