Caution:
The unit contains rotating blades and other dangerous items. Do not remove any safety cov-
ers from the machine. Be aware that loose jewelry, long hair and loose fitting clothes should be kept
away from the unit.
1.
Set the machine on a tabletop. Verify the power switch is set to "0" (off position).
2.
Look in each feed shelf of your unit, and verify that the tips of the sheet
retarder are not in contact with the feed wheels. These are preset at
the factory and should not need to be adjusted.
Note: If the machine
is operated with the retarder in contact with the feed wheels the
wheels could be damaged.
2a. Remove taped accessories from the exit tray shelves. These are
used as paper weights on top of the stack to insure accurate track-
ing of curled stocks, or for stocks that require additional control for
accurate feeding and registration. See Figure 2.
3.
Turn rocker switch to "1" . The unit should begin running. If there is no
power, try the following:
3a. Check the electrical outlet to verify function. A good way to do this is to plug in
another device that you know works.
3b. If still no power, check that circuit breaker has not tripped. Find source
of machine bind and correct. Allow machine to cool and push breaker in to reset.
3c. Call the technical support division at Martin Yale Industries, Inc. at 260-563-0641.
A paper support is utilized on the in feed of any bin where the sheets overhang the edge of the feed shelf. The
paper support is installed by inserting the tabs into the slots on the front of the feed shelves as shown in Figure
3. Install the paper support and collection bins onto the machine as shown in Figure 4. Keep in mind the bot-
tom shelf will be where the first pass is made and the shelf above it will be where the finished product is created.
4.0 Set up from carton to table
4.1
Tray/ Paper Support Installation
Make sure that the sheet
retarder tips are not touching
the feed wheel in each shelf
when the machine is turned on.
Retarder is factory set to .012
gap and should not need to be
adjusted for typical 65# stock.
Retarder
Make sure that the stack weights are
removed from the feed bins before
the machine is run for the first time.
Second Pass
First Pass
Paper Support
Collection
bin for fin-
ished cards
goes on top
shelf; large
collection
tray goes on
bottom.
Figure 1
Figure 2
Figure 3
Figure 4
2
7
