1501X OPERATIONAL INSTRUCTIONS
When putting paper into the machine, it should be a neat stack. Once the stack
is on the tray, press down and slide the stack against the retarder frame. After
squaring, allow the table to return to its upper position. At this point, the stack of
paper should be pressed against the feed roller.
SETTING THE FOLDS
In order to use the unit, you must first understand the different fold setups.
The first consideration is how to do a half fold as opposed to a tri- fold. in order
to do this, the second folding table must be repositioned on its mounting post to
disable it. (See photo below.)
First step in
doing a half
fold.
This is accomplished by pulling out on the bottom edge of the second folding
table and lowering it slightly so that is is aligned with the rubber grommet that
says ‘single fold’. When resecuring the table onto the mounting post, make sure
it is fully pressed into position. After this is performed, the second folding table
will be disabled and the table underneath the feed tray needs to be set for the
appropriate sheet size. This is typically going to be a half fold. There are icon
markings on the ruler for A4, 8 ½ X 11 and 8 ½ X 14.
When adjusting the paper stop brackets on the fold tables, make sure that they
are straight in alignment. Also, when tightening the knobs, be careful not to over
tighten.
Any time there are two folds in the stock, like a typical letter fold, the second fold
tables mounting post should be inserted into the double fold opening. (See photo
on next page.)
III
http://www.monomachines.com/
http://www.monomachines.com/
