TT4FK by Martin System™
5
b)
Put the USB charging cable into the USB port (10) of the
transmitter.
c)
Plug the charging cable into the adapter provided. Put the adapter
in an outlet and the battery icon in the display will flash.
d)
When the flashing stops, the TT4FK is full. This takes about 2
hours when it is totally empty. You will notice that the battery icon
will be steady and full.
e)
The transmitter can be on or off when starting the charging
procedure.
f)
When charged, just unplug the USB charging cable and slide the
silicon sleeve over the transmitter. The silicon sleeve helps to keep
the unit clean and dry. Once the sleeve is on again, you are ready
to go!
5.
Battery Level
The battery level of the remote is showed by the symbol Battery (6):
Two triangle : Half to Full
One Triangle : less than half
No triangle: nearly empty
The battery life time in standby is about 24h.
6.
How To Pair a Finger Kick:
a)
Push and hold the on/off button (8) for 15 seconds. (The
display will run 5 times through the stimulation programs.)
b)
The display will then start to flash.
c)
Release the on/off (8) button and press the Finger-Kick
button.
d)
The display will react by flashing faster when the pairing was
successful.
e)
Repeat if this was not successful.
7.
How To Use the Finger Kick
After pairing a Finger Kick, you only need to press the button, the behavior
will be the same than the Stimulation button (7) of the remote TT4FK
8.
How To Pair a training collar to the remote TT4FK
To program the receiver to operate with its remote control, the following
procedure must be carried out:
a)
Position and hold the Red Dot (9) or the Magnet against the
configuration point (Start and Stop) of the receiver until the
four LEDs flash quickly.
b)
Then separate the products and then press the Stimulation
Button (7)
c)
The collar receiver will react to the Stimulation button (7)
