Martin Professional MX-10 Extreme, User Manual

Page: 11 / 36

Control Panel 11
C
ONTROL
P
ANEL
You set the address and personalities, read out data, and execute service utilities from the control panel. Settings can
also be changed remotely via the serial link with the Martin MP-2 uploader.
There are four small symbols that can appear in the control panel display:
Menu navigation
See also the control menu table starting on page 28.
The DMX address and any error messages are displayed after the fixture resets. To enter the menu, press [menu]. Use
the [up] and [down] keys to move within the menu. To select a function or submenu, press [enter]. To escape a function
or menu, press [menu].
Address selection
The MX-10 Extreme requires 13 channels for DMX control. The address, also known as the start channel, is the first
channel used to receive instructions from the controller. For independent control, each fixture must be assigned its own
Tick/check Power is on and the fixture is ready
Disc
The fixture is writing to memory. Do not power off the fixture
while this symbol is lit.
Network The fixture is receiving DMX
Wrench/spanner Error
PATI AddR dMXL UTIL
Address/
Messages
STCO
SHUT
....
EFSP
AdJ
PCbT
UPLd
TSEQ
SWAP
PINV
TINV
PTSP
NORM
FAST
PERS dFSE INFO
SCUT
dISP
dINT
dLOF
ALON
FACT
CAL
dFOF
TIME
HRS
L HR
L ST
VER dRES
Figure 4: MX-10 Extreme menu
RST
L ON
LoFF
GOBO
SHUT
dIM
COL
FOC
PAN
TILT
I/S
RPRI
RATE
qUAL
PRIS
MAN
EFFb RUN
PINV