Martin Audio CDD-LIVE! Series, User Manual

Page: 68 / 83

CDD ‐ LIVE USER GUIDE
CDD ‐ LIVE User Guide V1.0
67
…………
Position the bracket and attach with the M8x35mm screws and fully tighten; ‐
The Universal Bracket has two fixing positions for a scaffold clamp, pole mount adaptor or other fixing method. These change
the available angles for up and down tilt. The top fixing position is the default and should always be used for pole mount
applications, the alternative angle fixing point towards the rear gives an additional 30° of down ‐ tilt for flown applications. Also
supplied with the Universal bracket is an aluminium spacer block. This may be used on the angle fixing position when attaching
a scaffold clamp to allow greater horizontal rotation if required.
The Universal Bracket should be fitted in position, suspended or mounted on a pole as required. To adjust the angle the plungers
are pulled out each side and rotated 90° to temporarily hold them in an unlocked position. The cabinet is then tilted up or down
as required, the bracket will slide in an arc on the carriage. Once in the desired position the plungers are then turned a further
90° so they spring back into position. Adjust the cabinet a fraction up and down to ensure that the plunger pins have securely
located into the holes on the Arc Bracket. The angles available in each of the index holes are as follows (note that these angles
refer to a flown system with positive angles as down tilt and negative as up ‐ tilt)
Central Mounting Hole Rear Angled mounting hole
15° 45°
12.5° 42.5°
10° 40°
8° 38°
6° 36°
4° 34°
2° 32°
0 ° 30 °
‐ 2° 28°
‐ 4° 26°
‐ 6° 24°
‐ 8° 22°
‐ 10° 20°
‐ 12.5° 17.5°
‐ 15° 15°