CODE SWITCH
1.
CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the
code used for both transmitter and receiver is exactly the same; otherwise remote controller will
not work. Please note the code switch will enable you to operate a second remote controller
independently. For example, if you have two ceiling fans with 2 remote control units, set 2
different codes for each set of transmitter/receivers. This means you can operate each ceiling fan
independently.
2.
Your remote control is ready for use after batterie
s
are installed.
(
2 x1.5V/AAA
Batteries
Included)
FUNCTIONS OF TRANSMITTER
: Turn off the ceiling fan.
: Turn on the fan at high speed
: Turn on the fan at medium speed
: Turn on the fan at low speed
: When fan turned on, press this key for set timer 1 to 8 hrs. for
turning off. For example, set 1hr. that the ceiling fan will turn off after 1
hour automatically.
: Press and release immediately to turn on or off the light
TRANSMITTER
Installation of
transmitter wall mount
holder with two screws.
