GETTING CONNECTED
PINCODE SETUP
1. Press the trigger for 1 second to activate the scanner.
2. Scan [
DISCONNECT
]
3. Scan [
BT mode - SPP
]; the scanner will emit several beeps.
4. Select “Wireless Scanner” from discovered device list.
The default pincode is “1234”.
5. Open serial communication software with com port
(see Device Manager) properly set up.
6. The scanner will beep twice to verify the connection.
There are two modes of wireless communication:
-
7
-
-
8
-
. E042$
BT mode - SPP
Pincode Start
*.E042$*
. E032$
*.E032$*
. E033$
*.E033$*
. E043$
BT mode - HID
*.E043$*
Disconnect
. E031$
*.E031$*
*$TX*
$TX
1. Press the trigger for 1 second to activate the scanner.
2. Scan [
DISCONNECT
]
3. Scan [
BT mode - HID
]; the scanner will emit several beeps.
4. Select “Wireless Scanner” from discovered device list.
5. The Bluetooth application may prompt you to scan
a pincode(see
PINCODE SETUP
section) it generated.
6. The scanner will beep twice to verify the connection.
Scan numeric barcodes
(see
NUMERIC BARCODES
section
on the next pages)
based on the pincode generated
by the Bluetooth application.
STEP 1
Pincode Stop
Enter
STEP 4
STEP 3
STEP 2
[ Recommended ]
