9
3.3.3 Motor change
Tools required
：
Qty
Large Phillips screwdriver 1
5mm inner hexagon spanner 1
8mm open-end spanner 1
17mm club spanner 1
1
）
Turn the ignition key at the “OFF”position: disassemble the seat and cover, take off the motor
connector wire; disassemble the 4 M10*45 column hut screws on the fixed frame of rear spring,
then take off the fixed frame.
2
）
Disassemble the 2 screws and the take out the motor.
3
）
Install the mew motor, pay attention to the handle of the clutch, make it at the correct
position(backward and lean on down), fasten the 2 tighten bolts.
4
）
Install all parts by the opposite sequence as disassemble.
3.6 Replace the front light bulb
1) Turn off the ignition key switch.
2)Loose the tighten bolts on the front light
and take off the front light.
3)The front light is integrity, so just replace
it and reinstall it is ok.
3.7 Replace the turning light bulb
1) Turn off the ignition key switch.
2) Turn the turning light by 90°
，
take off the light holder, disassemble the bulb and install the new bulb.
3) Install it by the opposite sequence as disassemble.
3.8 Replace the reverse buzzer
Tools required
：
Qty
Big truss-head screwdriver 1
Plier 1
Prick 2
1) Turn off the ignition key switch
Summary of Contents for DG24800
Page 1: ...1 DG24800 Manual...
