2.
Installation
User Manual VS-547-SGSDI – V1.0
Page 8 of 74
3/2016
2.1 Connecting Power
After confirming the Power Source, connect Power Adaptor and connect the 12VDC
Connector to the System.
2.2 Connecting Network
Plug the Network Cable into the Ethernet port (RJ-45 network port).
2.3 Connecting Video
1)
To display video through the composite or HD-SDI port, connect each port to a
monitor using BNC coaxial cable. To display video through the HDMI port, connect
the port to a monitor using the HDMI cable
.
2)
On the Video tab, the
Enable Preview
option should be set to
“ON”.
(Please refer
to the Video Configuration section for more details):
Video cannot be viewed if the BNC coaxial cable is not connected when using
HD-SDI.
If the video transmission distance is too far away, the video data may not be
transmitted due to a reduction in the video signal. In order to prevent this, install a
repeater in the middle.
When using HD-SDI, the video can be viewed on the HD-SDI monitor.
When using HDMI, the video can be viewed on the monitor supporting HDMI.
2.4 Connecting Audio
Audio is
Full-Duplex
. It is possible to set the mode as
Tx-only
,
Rx-only,
or
Tx-Rx
.
Connect audio input and output ports to audio devices accordingly.
The Audio signal required is line level, so audio equipment with an amp, mixer or
other amplifier should be used.
2.5 Connecting Serial Port (RS-485 Communication)
This IP Box Camera can be connected to external equipment such as a PT receiver,
etc. The camera can send PT commands via the Serial Ports.
When a Decoder System is used to connect the IP Box Camera to the Serial Port, the
Decoder System works in Pass-Through Mode (data from one port is delivered to the
other port.
2.6 Connecting Sensor and Alarm
Connect Sensor and Alarm Devices to corresponding terminals accordingly.
