Marshall Electronics V-MD173, Operating Instructions Manual, Page: 10 / 36

10
Input Module Installation
1. Remove Power From Unit

Modules are cold-swappable only. Damage will occur if modules are inserted or removed while unit is
powered.
2. Remove Blank Module Cover

Using Philips screwdriver, remove the 4-40x1/8” screws. There are a total of three screws, save them for later
use.

Remove blank cover
3. Insert Optional Module

Decide which slot you intend to install module (Slot 1 or Slot 2)

Carefully align the module with the chosen slot. The raised rails will fit inside the module

Align the Module so that the three (3) mounting holes all line up with the threaded holes of the slot.

The connectors on both the module and the main-board slot should now be in alignment.

Carefully PRESS the module into the slot. Module will seat flush with the rear of the unit.

Replace the three (3) screws removed in Step 2.
*NOTE* Use ONLY 4-40x1/8” screws provided. Any screw longer than 1/8” will damage the main unit.