English -
41
Chapter 7 DIP Switch Setting
7.1 DIP SWITCH
7.1.1
OUTPUT Switch
To switch via the OSD/ RS-232 Command is also available based on the last
executed action
ID
Resolution
Frame Rate
0
3840 x 2160
29.97
1
25
2
1920 x 1080
59.94
3
50
4
29.97
5
25
6
1280 x 720
59.94
7
50
8
29.97
9
25
A
Reserved
Reserved
B
C
D
E
F
7.1.2
IR SELECT
ID
Setting
1
2
3
English -
42
Chapter 8 Troubleshooting
This chapter describes problems you may encounter while using CV630-IP. If you have
questions, please refer to related chapters and follow all the suggested solutions. If the problem
still occurred, please contact your distributor or Marshall IP technical support.
No.
Problems
Solutions
1.
Boot without power
signal
1. Make sure you have plugged in the power cord.
2. When using a PoE connection, ensure that the power supply
supports POE+ (IEEE 802.3at) hubs
2.
There is no image
output from CV630-IP
1. Check the power supply or PoE supply functions.
2. Confirm the output signals are in streaming output.
3. Confirm whether the camera resolution can be used together
with the monitor equipment
■
If 4k output, confirm the monitor equipment supports 4K
output
4. Replace the cables and make sure they are not faulty.
3.
CV630-IP image is
severely delayed
Please use 1080p or 720p 60/50 fps rather than 25/30 fps
signals.
4.
RS-232 cannot be
controlled
1. Confirm the connection is correct (RS-232 In/ Out)
2. Please make sure the Baud rate setting is the same as the
control equipment
5.
Whether the Internet
can be used for
operation
Please refer to
Chapter 6 Network Function Description
for
the Internet usage
CV630-IP Manual
www.marshall-usa.com
41
42
