Joystick Control
The CV-PT-HEAD contains 10 gears. Some controllers can select any gear, but others can
only select a fewer number of gears. The movement is fully proportional to the joystick
displacement in all gears.
If the ‘turbo’ button is enabled on the controller this will set the speed to the fastest gear
triggered by holding down the button.
Pre-Set Positions
The
CV-PT-HEAD
has the capacity to store up to 64 pre-set positions although some
controllers can only access 4 positions. When first powering the unit on you will need to
manually set a ‘Home’ position or storing the positions you need. You can set a ‘Home’
position by using a known picture position from the camera or by driving it to the ends of the
pan and tilt travel. Doing this will enable it to re-call previously stored positions.
Connections
The
CV-PT-HEAD
is supplied with a short cable to connect it to a controller. This cable can
be simply extended following the wiring diagram below.
1 Blue (GND)
2 Green
3 Yellow
4 Red (+12v)
XLR4 (NC4MXX)
1 Blue (GND)
2 Green
3 Yellow
4 Red (+12v)
XLR4 (NC4FXX)
4 Pin Lemo input plug – FGG.0B.304.CLAD52Z
Pin 1 = GND (Blue)
Pin 2 = RS485 data A (Green)
Pin 3 = RS485 data B (Yellow)
Pin 4 = Power 12 – 35v (Red)
7 Pin Lemo plug for camera power & data - FGG.0B.307.CLAD52Z (not supplied)
Pin 1 = GND (Blue)
Pin 2 = RS422/485 data A TO camera (Green) Also semi-duplex return data.
Pin 3 = RS422/485 data B TO camera (Yellow) also semi-duplex return data.
Pin 4 = Power 12v camera power (Red)
Pin 5 = future use
Pin 6 = future use
Pin 7 = future use
When power is connected the blue LED on the side will flash 3 times whilst the
CV-PT-HEAD
is
booting up. After this sequence, the LED will indicate 3 states.
Permanently ON
= Power applied; data received but not being addressed.
Very Fast Flashing
= Being addressed and should respond to commands.
Flashing Very Slowly
= Power but no data.
